Airtag Rumble Adapter (B grade)
**THIS IS FOR THE 3D PRINTED PART ONLY, AN AIRTAG IS NOT INCLUDED**
This item is for Airtag Rumble Adapters that didn't print perfectly. They all fit properly and function the exact same but have visual imperfections (pictured).
Tired of losing your controller? Put an Airtag in it! This 3d printed part allows an airtag to snuggly fit into the rumble bracket on an OEM Gamecube Controller!
Unfortunately this will replace the existing rumble motor but there are alternatives if you need rumble, such as the Cell Phone Rumble that many modders offer.
Installation is very easy:
-Remove the 6 screws that hold the two shell halves together
-Open the controller (stick side down for the easiest disassembly/reassembly)
-Snip the wires for the rumble motor right where they attach to the board
-Remove the rumble motor
-Insert the Adapter with the Airtag seated in it into the rumble bracket (it's friction fit so make sure it's pushed in all the way or your controller won't close)
-Put the back shell back on and screw it back together!